CCL

Összesen 2 találat.
#/oldal:
Részletezés:
Rendezés:

1.

001-es BibID:BIBFORM095560
035-os BibID:(Scopus)85112640690
Első szerző:Ali, Hamid (mérnök)
Cím:Effect of the manufacturing parameters on the pore size and porosity of closed-cell hybrid aluminum foams / Hamid Ali, András Gábora, Muhammad Ali Naeem, Gábor Kalácska, Tamás Mankovits
Dátum:2021
ISSN:2062-0810 2063-4269
Tárgyszavak:Műszaki tudományok Anyagtudományok és technológiák idegen nyelvű folyóiratközlemény hazai lapban
folyóiratcikk
Megjelenés:International Review of Applied Sciences and Engineering. - 12 : 3 (2021), p. 230-237. -
További szerzők:Naeem, Muhammad Ail (1994-) (mérnök) Kalácska Gábor (mérnök) Mankovits Tamás (1981-) (gépészmérnök) Gábora András (1970-) (gépészmérnök, kohómérnök)
Internet cím:Szerző által megadott URL
DOI
Intézményi repozitóriumban (DEA) tárolt változat
Borító:

2.

001-es BibID:BIBFORM085290
Első szerző:Naeem, Muhammad Ail (mérnök)
Cím:Influence of the Manufacturing Parameters on the Compressive Properties of Closed Cell Aluminum Foams / Muhammad Ail Naeem, András Gábora, Tamás Mankovits
Dátum:2020
ISSN:0324-6051 1587-379X
Megjegyzések:The important properties of metallic foams such as good energy absorption, recyclability, noise absorption, etc. have put them at the forefront of technological development over recent years, especially for fields where the weight is a major concern. The production however, is a highly stochastic process which leads to their inhomogeneous nature. In this paper closed-cell aluminum foam specimens have been produced by direct foaming technique and investigated mechanically, following the principles of Taguchi Design of Experiments (DOE). The important compressive properties of the produced specimens such as the structural stiffness, yield strength, plateau stress and energy absorption have been measured through uniaxial compression tests and the effect of the manufacturing parameters (the temperature, the mixing speed and the amount of foaming agent added) on the energy absorption capacity of the foam is analyzed. From experiments, it was observed that the temperature is the most dominant control factor for the energy absorption capability of the foam followed by the foaming content and the mixing speed. ANOVA statistical analysis was also performed to determine the statistical significance of these parameters on the response.
Tárgyszavak:Műszaki tudományok Gépészeti tudományok idegen nyelvű folyóiratközlemény hazai lapban
folyóiratcikk
Megjelenés:Periodica Polytechnica, Mechanical Engineering. - 64 : 2 (2020), p. 172-178. -
További szerzők:Gábora András (1970-) (gépészmérnök, kohómérnök) Mankovits Tamás (1981-) (gépészmérnök)
Internet cím:Szerző által megadott URL
DOI
Intézményi repozitóriumban (DEA) tárolt változat
Borító:
Rekordok letöltése1