CCL

Összesen 4 találat.
#/oldal:
Részletezés:
Rendezés:

1.

001-es BibID:BIBFORM018664
Első szerző:Borda Jenő (vegyész)
Cím:Novel polyurethane elastomer continuous carbon fiber composites : Preparation and characterization / Jenő Borda, Sándor Kéki, Istvánné Ráthy, Ildikó Bodnár, Miklós Zsuga
Dátum:2007
ISSN:0021-8995
Megjegyzések:Preparation and characterization of novel polyurethane (PUR)-carbon fiber (CF) composites are reported. The reinforcement of PUR elastomers was achieved using unidirectional continuous CFs with different coatings (uncoated and epoxy and polyester resin coatings) by applying molding for the preparation of PUR-CF composites. Considerable reinforcement of PUR was attained even at relatively low CF content, e.g., maximum stress and Young's modulus of PUR-CF composite at CF content 3% (m/m) were found to be 3-5 and 4-10 times higher than those of the PUR-matrix, respectively. In addition, a linear relationship between the Young's modulus and the CF content was found as well as linear variation of maximum stress with the CF content was also observed. The adhesion of CF to the PUR-matrix was strong in each case as concluded from the strain-stress and the scanning electron microscopy (SEM) investigations. However, the extent of reinforcement of PUR at a given CF content was found to depend greatly on the coatings of CF, and increased in the following order: epoxy resin < polyester resin < uncoated. The effect of the coating of CF on the reinforcement of FUR is also discussed.
Tárgyszavak:Természettudományok Kémiai tudományok idegen nyelvű folyóiratközlemény külföldi lapban
polyurethane
reinforcement
composite coatings
Megjelenés:Journal of applied polymer science. - 103 : 1 (2007), p. 287-292. -
További szerzők:Kéki Sándor (1964-) (polimer kémikus) Ráthy Istvánné (1958-) (gépészmérnök) Bodnár Ildikó (1975-) (vegyész) Zsuga Miklós (1944-) (polimer kémikus)
Internet cím:Szerző által megadott URL
DOI
Intézményi repozitóriumban (DEA) tárolt változat
Borító:

2.

001-es BibID:BIBFORM013722
Első szerző:Borda Jenő (vegyész)
Cím:Synthesis and investigation of the mechanical properties of poly(lactic acid)-(toluene diisocyanate)-poly(ethylene glycol)/poly(propylene glycol) copolymers / Jenő Borda, Ildikó Bodnár, Istvánné Ráthy, Miklós Zsuga
Dátum:2003
ISSN:1042-7147
Megjegyzések:The synthesis and mechanical properties of the potentially biodegradable poly(lactic acid)-toluene diisocyanate-poly(ethylene glycol)/poly(propylene glycol) (PLA-TDI-PEG/PPG) copolymers were studied. There is a close connection between the optimal conditions of the synthesis and the mechanical properties, which were investigated in detail. The tensile characteristics of the copolymers were compared with those of commercially available foils. The carbon fiber reinforcement of these new biodegradable block copolymers is also reported.
Tárgyszavak:Természettudományok Kémiai tudományok idegen nyelvű folyóiratközlemény külföldi lapban
folyóiratcikk
poly(lactic acid)
copolymer
mechanical properties
biodegradable
Megjelenés:Polymers For Advanced Technologies. - 14 : 11-12 (2003), p. 813-819. -
További szerzők:Bodnár Ildikó (1975-) (vegyész) Ráthy Istvánné (1958-) (gépészmérnök) Zsuga Miklós (1944-) (polimer kémikus)
Internet cím:Szerző által megadott URL
DOI
Intézményi repozitóriumban (DEA) tárolt változat
Borító:

3.

001-es BibID:BIBFORM050365
Első szerző:Ráthy Istvánné (gépészmérnök)
Cím:Új típusú kompozitok előállítása / Ráthy Istvánné, Borda Jenő, Bodnár Ildikó, Horváth Róbert, Zsuga Miklós
Dátum:2002
ISSN:0027-2914
Tárgyszavak:Természettudományok Kémiai tudományok idézhető absztrakt
folyóiratcikk
Megjelenés:Műanyag és gumi. - 39 : 3 (2002), p. 71. -
További szerzők:Borda Jenő (1946-) (vegyész) Zsuga Miklós (1944-) (polimer kémikus) Bodnár Ildikó (1975-) (vegyész) Horváth Róbert (1948-) (gépészmérnök)
Internet cím:Intézményi repozitóriumban (DEA) tárolt változat
Borító:

4.

001-es BibID:BIBFORM043337
Első szerző:Ráthy Istvánné (gépészmérnök)
Cím:Moulded polyurethane based composites / Ráthy Istvánné, Borda Jenő, Bodnár Ildikó, Zsuga Miklós
Dátum:2005
Tárgyszavak:Természettudományok Kémiai tudományok előadáskivonat
Megjelenés:Proceedings from the 6th International scietific technical conference for V4 PhD students: Automation and CA Systems in Technology Planning and in Manufacturing : Herlany, 2-4.5.2005. - p. 235-240
További szerzők:Borda Jenő (1946-) (vegyész) Zsuga Miklós (1944-) (polimer kémikus) Bodnár Ildikó (1975-) (vegyész)
Internet cím:Intézményi repozitóriumban (DEA) tárolt változat
Borító:
Rekordok letöltése1