Magyar
Toggle navigation
Tudóstér
Magyar
Tudóstér
Keresés
Egyszerű keresés
Összetett keresés
CCL keresés
Egyszerű keresés
Összetett keresés
CCL keresés
Böngészés
Saját polc tartalma
(
0
)
Korábbi keresések
CCL parancs
CCL
Összesen 2 találat.
#/oldal:
12
36
60
120
Rövid
Hosszú
MARC
Részletezés:
Rendezés:
Szerző növekvő
Szerző csökkenő
Cím növekvő
Cím csökkenő
Dátum növekvő
Dátum csökkenő
1.
001-es BibID:
BIBFORM023575
Első szerző:
Sovilj, Bogdan
Cím:
Influence of coating on tool life of hob milling tool / Sovilj, B., Tiba, Zs., Kovač, P., Ješic, D., Sovilj-Nikič, I.
Dátum:
2010
ISSN:
1821-4932
Megjegyzések:
The hob milling is most widely applied in the course of machining serration of the cylindrical gear due to the high productivity of the process. The knowledge and investigation of the process of machining serration is of extreme importance for the manufacturers of the toothed gear. On the basis of analysis of the complex process of cutting of cylindrical gears by hob milling and performed simultaneous investigation of uncoated and coated hob milling in production conditions, this paper presents the possible significant cost reductions by application of coated tools.
Tárgyszavak:
Műszaki tudományok
Gépészeti tudományok
idegen nyelvű folyóiratközlemény külföldi lapban
hob milling wear
tool life
feed
cutting speed
gear
Megjelenés:
Journal of Production Engineering. - 13 : 1 (2010), p. 31-35. -
További szerzők:
Kovač, P.
Jesič, D.
Tiba Zsolt (1965-) (gépészmérnök)
Sovilj-Nikič, Ivan
Internet cím:
Intézményi repozitóriumban (DEA) tárolt változat
Szerző által megadott URL
Borító:
Saját polcon:
2.
001-es BibID:
BIBFORM012431
Első szerző:
Tiba Zsolt (gépészmérnök)
Cím:
Bending dynamic model adaptable to cutting / Zsolt Tiba, Bogdan Sovilj, Ivan Sovilj-Nikic
Dátum:
2010
Megjegyzések:
Cutting tools represent one very important parts in the chain of production. Due to its importance, knowledge of its behavior gives an opportunity to increase efficiency of cutting tools design.In this paper the bending, torsion dynamic models of diving chains and the computational simulation program based on the models with its adaptation on cutting tools are elaborated
Tárgyszavak:
Műszaki tudományok
Gépészeti tudományok
idegen nyelvű folyóiratközlemény külföldi lapban
dynamic model
excitation effects
natural bending frequencies
simulation program
Megjelenés:
Journal of Production Engineering. - 13 : 1 (2010), p. 37-39. -
További szerzők:
Sovilj, Bogdan
Sovilj-Nikič, Ivan
Internet cím:
Intézményi repozitóriumban (DEA) tárolt változat
Borító:
Saját polcon:
Rekordok letöltése
1
Corvina könyvtári katalógus v8.2.27
© 2023
Monguz kft.
Minden jog fenntartva.